![]() Be sure your door is properly adjusted.NEVER permit anyone to cross path of moving door.ALWAYS keep door in-sight until it has fully completed it’s travel and has come to a full stop.Set Keyless PIN for 940EVMC/877MAXMC Models: Program a Keypad PIN Using Your Garage Door Opener: Be sure to clear the garage door area of any obstructions.Locate the LEARN button on the garage door opener. ONLY activate the garage when it can be clearly seen, to ensure there are no obstructions in the doors travel path The PIN programming is complete.To test, enter your PIN, then press the ENTER button.NEVER permit children to operate, or play with remote control transmitters Be sure to clear the garage door area of any obstructions.Press the programmed PIN that you want to change.Press and hold the button until the garage door opener light blinks twice.Enter the new 4-digit PIN of your choice, then press the ENTER button.ALWAYS keep remote controls out of reach of children.To prevent possible SERIOUS INJURY or DEATH from a moving garage door ![]() Be sure NOT to be standing directly in the doors travel when testing your new code.NOTE: If the light bulbs have not been installed, or are not working, you will two clicks indicating the procedure is complete When the lights on the motor unit blink, you may release the “ENTER” button.Within 30 seconds, on the keypad, press in your new 4-digit code.BEWARE, be sure to “press and release” the learn button, holding the learn button pressed in, will erase all remote/transmitting devices that are already programmed into unit. The LED near the learn button will light for 30 seconds. You may need to remove the visor clip to find the model number on other models. Most remote control model numbers can be located on a sticker on the back of the remote. On the motor unit, press and release the “Learn” button (normally located on the rear side). This article overview contains programming information for the different remote control models we support.(please read the warning and precautions before starting) The keypad will activate the opener even if the “Door Control Lock Switch” or “Vacation Switch” are on.Pressing the “Enter” button during this time will STOP or REVERSE the doors travel The keypad will blink for 15 seconds after the code is transmitted. ![]() The “ENTER” button will only transmit the last 4 digits pressed ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |